# Question: When Jumping A Car Where Do You Connect The Negative?

## Do you connect positive or negative first when jumping a car?

To Jump Start a Car With Cables, Follow These Steps: …

Connect the other red (positive) cable to the positive terminal of the good battery.

4.

Connect one end of the black (negative) jumper cable to the negative terminal of the good battery..

## What happens if you connect the negative terminal first?

If you first connect the negative cable, then when you connect the positive cable there is a chance the wrench will complete a circuit between the battery and the chassis of the car. … If the battery is offgassing, the spark could ignite those gases causing an explosion.

## Do you hook up red or black first?

Safety: Always remove the negative cable first, then the positive cable. When you connect the battery, connect the positive end first. Here is the order: Remove black, remove red, attach red, attach black. Ensure that the connections on both end are secure by trying to move the battery around.

## How do you ground a car when jumping?

9) Second, connect one end of the jumper cable’s black/negative clamps to the negative terminal of the good battery. 10) Finally, connect the remaining black/negative jumper cable clamp to a “ground” on the car to be jump-started. A “ground” is a metallic/unpainted part of the engine or frame/chassis.

## Does revving the engine while jumping a car help?

RAY: So by revving your engine up to 2,000 rpm or 2,500 rpm and holding it there while the other car tries to start, you’re increasing the output of your alternator and giving your battery a little bit of extra power, which it can donate to the other car. …

## What happens if I connect positive to negative?

A rapid spike in the electrical power from the donor battery will damage the dead battery and the vehicle’s electrical systems. … If you accidentally connect the negative clamp to the positive pole, the fuse should take the brunt of the power surge and burnout.

## Why do you connect the positive terminal first?

Connect positive first, negative having less potential won’t arc. The higher the voltage, the greater the chance of arcing and fusion. On a car if negative first and you are touching any metal part of car, when attaching positive there is possibility of arcing through you. Your body becomes part of the circuit.

## Why don’t you connect the negative when jumping a car?

Caution: Don’t attach the negative cable to the negative terminal of the weak battery when jumping a car battery! This common mistake could ignite hydrogen gas directly over the battery. Battery explosions can cause serious injury. … Finally, remove the positive cable from the car with the weak battery.

## What happens when you jump a car the wrong way?

When you jump start your car the wrong way, there are many things that could possibly happen. The battery, jumper cables, and electronics will be damaged, including the fuse and the sensors. There is even a risk of explosion when the problem is at its worst. … In most instances, you need to check the fuse.

## Do you have to ground when jumping a car?

It should not matter. Vehicles tend to have the negative connected to the ground. When jump starting a car, I would first connect the + to + on the two batteries and then either the – to – or negative to any exposed metal part. It should not matter.

## What color do you hook up first when jumping a car?

In order to allow for a jump start to work properly, one must ensure that the correct terminals are being connected. The red cable will always represent the side that should be attached to the positive terminal, and the black should be attached to the negative terminal.

## Can you connect the negative cable?

Never connect the black cable to the negative (–) terminal on your dead battery. This is very dangerous, could result in a possible explosion. Make sure you follow the instructions in your owner’s manual when jumpstarting your vehicle. Every car is different.